Toyota Tundra 2005 Service - Repair - Maintenance page 2341

AUTOMATIC TRANSMISSION (A750E, A750F)
A
Dimension B
− AUTOMATIC TRANSMISSION UNIT (1GR−FE)
INSTALLATION
1. CHECK TORQUE CONVERTER INSTALLATION
(a) Install the torque converter to the transmission housing.
(b) Using vernier calipers and a straight edge, measure di-
mension A between the transmission fitting part and the
converter fitting part of the drive plate.
D14129
(c) Using vernier calipers and a straight edge, measure di-
mension B shown in the illustration and check that B is
greater than A measured in step (b).
Standard distance: A + 1 mm (0.04 in.) or more
2. MEASURE DRIVE PLATE RUNOUT AND INSPECT
RING GEAR (See page AT−39)
3. TRANSMISSION INSTALLATION
(a) Installation is in the reverse order of removal
(See page AT−27).
D14130
(b) Adjust the shift lever position (See page DI−952).
(c) Fill the transmission (See page AT−4).
(d) Conduct the road test of the vehicle (See page DI−953).
AT−31
AT13Z−01