Upward
CHARGING (2UZ−FE)
−
6.
INSTALL BRUSH HOLDER AND VOLTAGE REGULA-
TOR
(a)
Place the seal plate on the rectifier end frame.
B04532
(b)
Place the voltage regulator and brush holder on the recti-
fier end frame.
NOTICE:
Be careful of the brush holder installation direction.
(c)
Install the 5 screws.
Torque: 1.96 N·m (20 kgf·cm, 17 in.·lbf)
B16394
7.
INSTALL REAR END COVER
(a)
Place the brush holder cover on the brush holder.
B16395
(b)
Install the end cover and plate terminal with the bolt and
3 nuts.
Torque:
Bolt: 3.85 N·m (39 kgf·cm, 34 in.·lbf)
Nut: 4.4 N·m (46 kgf·cm, 39 in.·lbf)
B16391
(c)
Install the terminal insulator with the nut.
Torque: 4.1 N·m (41.5 kgf·cm, 36 in.·lbf)
8.
CHECK THAT ROTOR ROTATES SMOOTHLY
B16399
GENERATOR (Standard Spec.)
CH−15