Toyota Tundra 2005 Service - Repair - Maintenance page 2860

SUPPLEMENTAL RESTRAINT SYSTEM - CURTAIN SHIELD AIRBAG ASSEMBLY
INSTALLATION
HINT:
z
Use the same procedures for the RH side and LH side.
z
The procedures listed below are for the LH side.
1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
(a) Install the curtain shield airbag assembly with the 13
bolts.
Torque: 9.8 N·m (100 kgf·cm, 7 ft·lbf)
CAUTION:
Pay attention not to twist the deployment section of the cur-
tain shield airbag assembly.
NOTICE:
z
If the curtain shield airbag assembly has been
dropped, or there are cracks, dents or other defects
in the case or connector, replace the curtain shield
airbag assembly with a new one.
z
When installing the curtain shield airbag assembly,
take care that it is not pinched between other parts.
z
Never use airbag parts from another vehicle. When
replacing parts, replace them with new ones.
(b) Connect the connector of the curtain shield airbag as-
sembly.
2. INSTALL ROOF HEADLINING (SEE PAGE
AND BO-138 )
3. CONNECT CABLE TO NEGATIVE BATTERY TERMI-
NAL
4. INSPECT SRS WARNING LIGHT (SEE PAGE
Author :
RS-93
RS0TH-08
H23220
BO-130
DI-1859
Date :
4508
)