Toyota Tundra 2005 Service - Repair - Maintenance page 2868

SUPPLEMENTAL RESTRAINT SYSTEM
H23879
- FRONT AIRBAG SENSOR
REMOVAL
HINT:
z
Use the same procedures for the RH side and LH side.
z
The procedures listed below are for the LH side.
NOTICE:
z
If the wiring connector of the SRS is disconnected
with the ignition switch in the ON position, DTCs will
be recorded.
z
Never use airbag parts from another vehicle. When
replacing parts, replace them with new ones.
z
Never reuse a front airbag sensor if the airbag has
previously deployed in a collision.
1. PRECAUTION (SEE PAGE
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
Wait for 90 seconds after disconnecting the cable to prevent the
airbag working.
3. REMOVE FRONT AIRBAG SENSOR LH
(a) Disconnect the front airbag sensor LH connector.
NOTICE:
Disconnect the connector with the sensor assembly
installed.
(b) Remove the 2 nuts and front airbag sensor LH.
Author :
RS-101
RS-1 AND RS-3 )
Date :
RS0I2-04
4516