Toyota Tundra 2005 Service - Repair - Maintenance page 2232

CL−8
Z08053
Q02470
Protrusion
1.5 to 3.5 mm
(0.059 to 0.138 in.)
Q02471
CLUTCH − CLUTCH MASTER CYLINDER
REASSEMBLY
1. COAT PARTS WITH LITHIUM SOAP BASE GLYCOL
GREASE, AS SHOWN
2. INSERT PISTON WITH SPRING INTO CYLINDER
3. INSTALL PUSH ROD AND BOOT
(a) Install the washer to the push rod.
(b) Push the push rod into the piston, and install the snap ring
using snap ring pliers.
(c) Install the boot.
4. TEMPORARILY INSTALL LOCK NUT AND CLEVIS
5. INSTALL RESERVOIR
(a) Install the reservoir and a new grommet.
(b) Using a pin punch and hammer, drive in the slotted spring
pin.
CL083−03