Toyota Tundra 2005 Service - Repair - Maintenance page 2613

BRAKE − BRAKE BOOSTER ASSEMBLY (Double Cab)
REMOVAL
NOTICE:
S
Do not adjust the brake booster push rod.
S
Do not change the combination of the diameter con-
verting unit and brake.
1. REMOVE MASTER CYLINDER (See page BR−26)
2. DISCONNECT VACUUM HOSE FROM BRAKE
BOOSTER
3. REMOVE SCUFF PLATE LH, COWL SIDE TRIM LH,
LOWER FINISH PANEL AND NO. 2 HEATER TO REG-
ISTER DUCT (See page BO−111)
4. REMOVE PEDAL RETURN SPRING
5. REMOVE CLIP AND CLEVIS PIN
6. REMOVE BRAKE BOOSTER
(a) Remove the 4 nuts and clevis.
(b) Pull out the brake booster and gasket.
(c) Remove the 2 stopper rings, brake booster bracket and
gasket from the brake booster.
F08326
BR−37
BR1XG−02