Toyota Tundra 2005 Service - Repair - Maintenance page 2381

TR−32
TRANSFER − INPUT SHAFT
INSPECTION
1. REMOVE OIL SEAL RING
Remove the 2 oil seal rings.
2. INSPECT INPUT SHAFT
(a) Using a micrometer, measure the outer diameter of the in-
put shaft journal surface.
Minimum diameter: 47.59 mm (1.8736 in.)
If the outer diameter is less than the minimum, replace the input
shaft.
Q07292
(b) Using a dial indicator, measure the inside diameter of the
input shaft bushing.
Maximum inside diameter: 39.14 mm (1.5409 in.)
If the inside diameter exceeds the maximum, replace the input
shaft.
Q07293
3. INSTALL OIL SEAL RING
Install the 2 oil seal rings.
HINT:
S
Apply gear oil to the oil seal ring.
S
Engage securely to eliminate clearance as shown in the
illustration.
Q07296
TR09Q−02