Toyota Tundra 2005 Service - Repair - Maintenance page 2264

Notch
SST
SST
SST
SST
MANUAL TRANSMISSION (RA60)
Protruding Part
D13930
D13927
A
D13931
D14040
D14041
− MANUAL TRANSMISSION ASSEMBLY
REASSEMBLY
1. REASSEMBLE FRONT CASE
(a) Install the oil receiver pipe to the front case.
HINT:
Make sure that the protruding part on the oil receiver pipe is
fitted into the notch on the front case.
(b) Using snap ring pliers, install the 2 snap rings.
(c) Using SST and a hammer, tap in a new oil seal to the
clutch housing until dimension A falls within the specified
range.
SST 09388−40010
Dimension A: 60.0 to 60.8 mm (2.362 to 2.394 in.)
(d) Apply gear oil to the lip of the oil seal.
2. REASSEMBLE REAR CASE
(a) Using SST and a press, press in 2 new bearing outer
races.
SST 09950−60020 (09951−00790, 09951−00850)
09950−70010 (09951−07100, 09951−07360)
(b) Using SST and a press, press in a new counter gear rear
bearing.
SST 09950−60010 (09951−00650), 09950−70010
(09951−07360)
MT−21
MT0HT−01