Toyota Tundra 2005 Service - Repair - Maintenance page 2292

1st
Reverse 2nd
1st
2nd
Reverse
SST
MANUAL TRANSMISSION (RA60)
DISASSEMBLY
1.
Using a dial indicator, measure the clearance between the gear
and the shaft.
D13977
2.
Using a dial indicator, measure the clearance between the gear
and the shaft with the needle roller bearing installed.
If necessary, replace the gear, needle roller bearing or shaft.
D13978
3.
(a)
D13979
(b)
D14115
4.
(a)
D13981
− COUNTER GEAR
INSPECT EACH GEAR THRUST CLEARANCE
Standard gear thrust clearance:
Gear
1st and 2nd
Reverse
INSPECT EACH GEAR RADIAL CLEARANCE
Standard gear radial clearance:
Gear
1st and 2nd
Reverse
REMOVE NEEDLE ROLLER BEARING INNER RACE
Using a snap ring expander, remove the snap ring.
Using SST and a press, remove the needle roller bearing
inner race.
SST 09950−00020
REMOVE REVERSE GEAR
Using a snap ring expander, remove the snap ring.
Thrust Clearance mm (in.)
0.10 to 0.43 (0.0039 to 0.0169)
0.12 to 0.37 (0.0047 to 0.0146)
Radial Clearance mm (in.)
0.015 to 0.067 (0.00059 to 0.00264)
0.015 to 0.065 (0.00059 to 0.00256)
MT−49
MT0I3−01