Toyota Tundra 2005 Service - Repair - Maintenance page 2082

Recommended Viscosity (SAE):
5W−30
°F −20
0 20 40
°C
−29 −18 −7 4
TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
Oil Pressure Gauge
Oil Pressure Switch
Adhesive
LUBRICATION (2UZ−FE)
OIL AND FILTER
INSPECTION
1.
Check the oil for deterioration, entry of water, discoloring or thin-
ning.
If the quality is visibly poor, replace the oil.
60 80 100
16 27 38
B16233
2.
The oil level should be between the "L" and "F" marks on the dip-
stick.
If low, check for leakage and add oil up to the "F" mark.
NOTICE:
Do not fill with engine oil above the "F" mark.
3.
4.
5.
6.
Allow the engine to warm up to normal operating temperature.
7.
B07230
8.
9.
(a)
(b)
10.
11.
P08343
− OIL AND FILTER
CHECK ENGINE OIL QUALITY
Oil grade:
ILSAC multigrade engine oil.
CHECK ENGINE OIL LEVEL
REMOVE ENGINE UNDER COVER
REMOVE OIL PRESSURE SWITCH
INSTALL OIL PRESSURE GAUGE
WARM UP ENGINE
CHECK OIL PRESSURE
Oil pressure:
At idle
At 3,000 rpm 294 − 588 kPa (3.0 − 6.0 kgf/cm
REMOVE OIL PRESSURE GAUGE
REINSTALL OIL PRESSURE SWITCH
Apply adhesive to 2 or 3 threads of the oil pressure switch.
Adhesive:
Part No. 08833−00080, THREE BOND 1344, LOCTITE
242 or equivalent
Reinstall the oil pressure switch.
START ENGINE, AND CHECK FOR ENGINE OIL
LEAKS
REINSTALL ENGINE UNDER COVER
2
29 kPa (0.3 kgf/cm , 4.2 psi) or more
2
LU−1
LU0GV−05
, 43 − 85 psi)