Toyota Tundra 2005 Service - Repair - Maintenance page 2166

ST−6
Engine Wire Protector
Starter
Connector
STARTING (2UZ−FE) −
REMOVAL
1. REMOVE THROTTLE BODY COVER
2. DISCONNECT CABLE FROM NEGATIVE (−) BATTERY
TERMINAL
3. REMOVE INTAKE AIR CONNECTOR
4. DISCONNECT THROTTLE BODY ASSEMBLY FROM
INTAKE MANIFOLD (See pege SF−44)
5. REMOVE INTAKE MANIFOLD ASSEMBLY
(See page EM−36)
6. REMOVE AIR PUMP ASSEMBLY (See page EC−23)
7. REMOVE STARTER
(a) Remove the 2 bolts holding the starter to the cylinder
block.
(b) Disconnect the starter from the cylinder block.
B04548
(c) Disconnect the starter connector.
(d) Remove the nut, bolt and disconnect the starter wire.
(e) Remove the bolt, and disconnect the engine wire protec-
tor from the starter.
(f) Remove the starter.
B04549
STARTER
ST08C−05