Toyota Tundra 2005 Service - Repair - Maintenance page 2377

TR−28
TRANSFER
REASSEMBLY
1. INSTALL FRONT DRIVE CLUTCH SLEEVE ONTO
REAR OUTPUT SHAFT
(a) Install the front drive clutch sleeve onto the rear output
shaft.
NOTICE:
Make sure that the clutch sleeve is installed in the correct
direction.
F07993
(b) Install the 3 shifting keys and 2 springs.
Shifting Key
NOTICE:
Install the key springs so that their end gaps are not in line.
F07994
2. INSTALL SYNCHRONIZER OUTER, CENTER AND IN-
NER RINGS, DRIVE SPROCKET, SPACER AND BEAR-
ING
(a) Apply gear oil to the rear output shaft and needle roller
bearing.
(b) Install the synchronizer outer ring to the rear output shaft.
NOTICE:
Align the slots of the synchronizer outer ring with the shift-
ing keys.
(c) Install the synchronizer center and inner rings to the rear
output shaft.
NOTICE:
Align the slots of the synchronizer outer with those of inner
rings.
F07995
− REAR OUTPUT SHAFT
TR09P−03