Toyota Tundra 2005 Service - Repair - Maintenance page 2386

SST
SST
SST
SST
TRANSFER − OIL SEAL
REPLACEMENT
1. IF NECESSARY, REPLACE FRONT BEARING RETAIN-
ER OIL SEAL
(a) Using a screwdriver and hammer, drive out the oil seal.
(b) Using SST and a hammer, drive in a new oil seal until its
surface is flush with the retainer upper surface.
SST
F19945 (c) Coat the lip of the oil seal with MP grease.
2. IF NECESSARY, REPLACE FRONT CASE OIL SEAL
(a) Using a screwdriver and hammer, drive out the oil seal.
(b) Using SST and a hammer, drive in a new oil seal until its
surface is flush with the case upper surface.
SST
(c) Coat the lip of the oil seal with MP grease.
F19946
3. IF NECESSARY, REPLACE EXTENSION HOUSING
OIL SEAL
(a) Using a screwdriver and hammer, drive out the oil seal.
(b) Using SST and a hammer, drive in a new oil seal until its
surface is flush with the housing upper surface.
SST
(c) Coat the lip of the oil seal with MP grease.
F19947
4. IF NECESSARY, REPLACE FRONT AND REAR COM-
PANION FLANGE OIL SEALS
(a) Using a screwdriver and hammer, drive out the 2 oil seals
from the 2 flanges.
(b) Using SST and a hammer, drive in 2 new oil seals.
SST
(c) Coat the lip of the oil seal with MP grease.
Q07442
09950−60010 (09951−00590), 09950−70010
(09951−07100)
09316−60011 (09316−00011)
09554−22010
09950−60010 (09951−00220, 09951−00350,
09952−06010), 09950−70010 (09951−07100)
TR−37
TR09R−02