Toyota Tundra 2005 Service - Repair - Maintenance page 2405

PR−12
PROPELLER SHAFT
INSPECTION
NOTICE:
Be careful not to grip the propeller shaft tube too tightly in
a vise as this will cause deformation.
1.
Using a dial indicator, check the runout of each shaft.
Z04240 If shaft runout is greater than the maximum, replace it.
2.
(a)
(b)
If the spider bearing axial play exceeds the maximum, replace
Z04241
it (See page PR−17).
3.
Check that the bearing turns freely.
If the bearing is damaged, worn, or does not turn freely, replace
it.
R04478
4.
(a)
(b)
If any problem is found, replace the propeller shaft assembly.
Double Cardan HINT:
Joint
A double cardan joint is used on the rear propeller shaft.
R04479
− PROPELLER SHAFT ASSEMBLY (4WD)
INSPECT PROPELLER SHAFT AND INTERMEDIATE
SHAFT FOR DAMAGE OR RUNOUT
Maximum runout: 0.8 mm (0.031 in.)
INSPECT SPIDER BEARING
Inspect the spider bearing for wear or damage.
Using a dial indicator, check the spider bearing axial play
by turning the yoke of the flange while holding the shaft
tightly.
Maximum bearing axial play:
Front propeller shaft: 0.05 mm (0.0020 in.)
Rear propeller shaft: 0 mm (0 in.)
Rear propeller shaft:
INSPECT CENTER SUPPORT BEARING FOR WEAR
OR DAMAGE
Rear propeller shaft:
INSPECT DOUBLE CARDAN JOINT PROPELLER
SHAFT
Inspect the shaft for wear or damage.
Inspect the double cardan joint for wear or damage.
PR01P−03