Toyota Tundra 2005 Service - Repair - Maintenance page 2364

TRANSFER − TRANSFER ASSEMBLY
REASSEMBLY
HINT:
Coat all of the sliding and rotating surfaces with gear oil before
reassembly.
1. INSTALL PLANETARY RING GEAR
(a) Install the planetary ring gear.
NOTICE:
Make sure that the planetary ring gear is installed in the
Q07290 correct direction.
(b) Install the pin and spring.
(c) Apply sealant to the head screw plug threads.
Sealant:
Part No. 08833−00080, THREE BOND 1344, LOCTITE
242 or equivalent
(d) Install the head screw plug.
Torque: 19 N·m (190 kgf·cm, 14 ft·lbf)
Q07241
(e) Using a screwdriver, install the snap ring.
NOTICE:
Make sure the end gap of the snap ring is not aligned with
the upper side of the case.
Q07240
2. INSTALL INPUT SHAFT ASSEMBLY, THRUST BEAR-
ING AND RACE
Q07437
3. INSTALL THRUST WASHER AND INPUT GEAR STOP-
PER
(a) Install the thrust washer, ball and input gear stopper.
HINT:
Apply gear oil to the input gear stopper and thrust washer.
F19349
TR−15
TR09L−03