Toyota Tundra 2005 Service - Repair - Maintenance page 2369

TR−20
TRANSFER
(d) Install the shift fork shaft stopper with the bolt.
Torque: 19 N·m (190 kgf·cm, 14 ft·lbf)
F07966
(e) Using a screwdriver and hammer, drive in the 2 snap rings
to the shift fork shaft.
F08462
(f) Install the 2 balls and springs to the front drive and high
and low shift forks.
(g) Apply sealant to the straight screw plug threads.
Sealant:
Part No. 08833−00080, THREE BOND 1344, LOCTITE
242 or equivalent
(h) Using a hexagon wrench (6 mm), install the 2 straight
screw plugs to the front drive and high and low shift forks.
Torque: 19 N·m (190 kgf·cm, 14 ft·lbf)
F07965
13. REASSEMBLE FRONT AND REAR CASE
HINT:
FIPG
Remove any FIPG material and be careful not to drop oil on the
contacting surface of the rear case.
(a) Apply FIPG to the rear case as shown in the illustration.
FIPG:
Part No. 08826−00090,
THREE BOND 1281 or equivalent
Q07161
(b) Install the 2 clamps and reassemble the front and rear
case with the 12 bolts.
Torque: 28 N·m (285 kgf·cm, 21 ft·lbf)
14. INSTALL VEHICLE SPEED SENSOR DRIVE GEAR
(a) Install the ball to the rear output shaft.
(b) Install the vehicle speed sensor drive gear and 2 output
washers.
F19348
− TRANSFER ASSEMBLY