Toyota Tundra 2005 Service - Repair - Maintenance page 2050

CO−6
COOLING (2UZ−FE) − WATER PUMP
REMOVAL
1. DRAIN ENGINE COOLANT
2. REMOVE TIMING BELT (See page EM−16)
3. REMOVE NO.2 IDLER PULLEY (See page EM−16)
4. REMOVE WATER INLET AND INLET HOUSING AS-
SEMBLY
(a) Disconnect the water bypass hose from the water inlet
housing.
(b) Remove the 2 bolts holding the water inlet housing to the
water pump.
(c) Disconnect the water inlet housing from the front water
bypass joint, and remove the water inlet and inlet housing
assembly.
B17478
(d) Remove the O−ring from the water inlet housing.
5. REMOVE WATER PUMP
(a) Remove the 5 bolts, 2 stud bolts, nut, water pump and
gasket.
(b) Remove the O−ring from the water bypass pipe.
B17479
CO0IR−07