Toyota Tundra 2005 Service - Repair - Maintenance page 2261

MT−18
SST
SST
MANUAL TRANSMISSION (RA60)
(c)
D13925
(d)
NOTICE:
Do not strike the front case with excessive force. If the out-
put shaft, input shaft, counter gear shaft and control sub
assembly are subjected to a strong impact, the balls or
springs may fly out of the clutch hubs.
(e)
D13926
21.
(a)
D14033
(b)
D14034
(c)
D14035
− MANUAL TRANSMISSION ASSEMBLY
While expanding the 2 snap rings, raise the output shaft,
input shaft, counter gear shaft and control sub assembly.
While tapping on the front case with a plastic hammer, re-
move the output shaft, input shaft, counter gear shaft and
control sub assembly as a unit.
Separate the output shaft, input shaft, counter gear shaft
and control sub assembly.
DISASSEMBLE EXTENSION HOUSING
Using SST, remove the oil separator.
SST 09308−55010, 09520−00031
Remove the oil receiver pipe.
Using SST, remove the oil seal.
SST 09308−55010, 09520−00031