Toyota Tundra 2005 Service - Repair - Maintenance page 2334

AT−24
AUTOMATIC TRANSMISSION (A750E, A750F) − COLUMN SHIFT ASSEMBLY
INSTALLATION
1. INSTALL SHIFT LEVER HOUSING
Using a torx® socket wrench, install the shift lever housing with
the 3 new screws.
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
2. INSTALL SHIFT LEVER
(a) Install the upper No. 2 steering column cover.
(b) Using a torx® socket wrench, install the shift lever with a
new screw.
Torque: 18 N·m (180 kgf·cm, 13 ft·lbf)
(c) Connect the connector.
3. INSTALL PARKING LOCK CABLE NO. 1 AND NO. 2
(a) Apply MP grease on the lock pin and internal surface of
shift lever housing.
(b) Install the spring and parking lock cable No. 1 into the shift
lever housing.
NOTICE:
Be careful not to bend or twist the cable abnormally.
(c) Using a torx® socket wrench, install 2 new screws.
Torque: 2.9 N·m (29 kgf·cm, 25 in.·lbf)
(d) Wire the cable No. 1 and No. 2, as shown in the illustra-
tion.
(e) Temporarily install the cable housing to steering column
assembly with 2 new bolts.
NOTICE:
Be careful not to bend or twist the cable abnormally.
D05181
(f) After installation, confirm the following items.
(1) When the shift lever is in the P position and the ped-
al button is pushed in by 7 mm (0.28 in.), shift lever
should be locked by lock pin.
(2) When the pedal button is released, the shift lever
should be able to be shifted from P position to other
positions.
(3) When the shift lever is in the N or D position and the
pedal button is pushed in by 7 mm (0.28 in.), the
D05182
shift lever should be able to be shifted.
AT13W−01