Toyota Tundra 2005 Service - Repair - Maintenance page 2406

Front propeller shaft:
Rear propeller shaft:
Front
PROPELLER SHAFT
REASSEMBLY
NOTICE:
Be careful not to grip the propeller shaft tube too tightly in
a vise as this will cause deformation.
HINT:
When removing or installing any part, make sure that each joint
is facing the correct direction, as shown in the illustration below.
1.
HINT:
Install the center support bearing in the direction shown.
Q07493
2.
Matchmarks
(a)
(b)
(c)
HINT:
If replacing either the center flange or intermediate shaft, reas-
semble it so that the front side flange yoke of the intermediate
shaft and the rear side flange yoke of the propeller shaft are fac-
PR0011
ing in the same direction.
− PROPELLER SHAFT ASSEMBLY (4WD)
Rear propeller shaft:
INSTALL CENTER SUPPORT BEARING ON INTER-
MEDIATE SHAFT
Rear propeller shaft:
INSTALL FLANGE ON INTERMEDIATE SHAFT
Coat the splines of the intermediate shaft with MP grease.
Install the spacer.
Place the flange on the shaft and align the matchmarks.
PR−13
PR01Q−03
F19335