Toyota Tundra 2005 Service - Repair - Maintenance page 2319

AUTOMATIC TRANSMISSION (A750E, A750F)
Bolt
Orange
Blue
Clamp
Bolt
B
Orange
Blue
Clamp
A
ATF TEMPERATURE SENSOR
ON−VEHICLE REPAIR
1.
(a)
(b)
2.
3.
D13867
4.
Clamp
(a)
(b)
D12704
(c)
(d)
5.
(a)
(b)
(c)
D12739
(d)
Clamp
(e)
HINT:
In order to install the ATF temperature sensors properly, check
the wire harness color prior to installation.
D12704
Sensor wire harness:
6.
− ATF TEMPERATURE SENSOR
DRAIN AUTOMATIC TRANSMISSION FLUID
Remove the drain plug and gasket, and drain the ATF.
Install a new gasket and the drain plug.
Torque: 20 N·m (204 kgf·cm, 15 ft·lbf)
REMOVE OIL PAN (See page AT−12)
REMOVE OIL STRAINER (See page AT−12)
REMOVE ATF TEMPERATURE SENSOR
Disconnect the 7 solenoid valve connectors.
Remove the 2 bolts, clamps and ATF temperature sen-
sors.
Disconnect the transmission wire connector.
Remove the bolt and the transmission wire harness.
INSTALL ATF TEMPERATURE SENSOR
Install the transmission wire harness.
Install the bolt.
Torque: 5.4 N·m (55 kgf·cm, 48 in.·lbf)
Connect the transmission wire connector.
Connect the 7 solenoid valve connectors.
Install the 2 ATF temperature sensors and clamps to the
valve body with the 2 bolts.
Torque:
A: 11 N·m (112 kgf·cm, 8 ft·lbf)
B: 10 N·m (100 kgf·cm, 7 ft·lbf)
Bolt length:
Bolt A: 36 mm (1.42 in.)
Bolt B: 12 mm (0.47 in.)
Wire harness
for linear control
for oil temp. warning lamp
INSTALL OIL STRAINER (See page AT−12)
AT−9
AT13N−01
Color
Orange
Blue