Toyota Tundra 2005 Service - Repair - Maintenance page 2315

AUTOMATIC TRANSMISSION (A750E, A750F)
DLC3:
CG
1 2 3 4 5
9 10 11 12 13 14 15 16
TC
Specified Fluid Level
4.
(a)
(b)
5.
(a)
(b)
6 7 8
D13649
HINT:
The fluid temperature should be less than 30_C (86_F) before
check the fluid temperature.
6.
NOTICE:
The fluid temperature must be between 46_C (115_F) and
56_C (130_F) to check the fluid level.
Overflow Tube
(a)
(b)
If fluid does not come out, proceed to step 7.
If fluid comes out, wait until the over−flow slows to a trickle and
proceed to step 8.
D14351
− AUTOMATIC TRANSMISSION FLUID
FLUID CIRCULATION
Allow the engine to idle with the air conditioning OFF.
Move the shift lever through entire gear range to circulate
fluid.
FLUID TEMPERATURE CHECK
With hand−held tester
(1) Connect the hand−held tester to the DLC3.
(2) Select the tester menus: OBD/MOBD, ENGINE,
DATA LIST and A/T.
(3) Check A/T OIL TEMP.
(4) Allow the engine to idle until the fluid temperature
reaches 46_C (115_F).
Without hand−held tester (Using A/T OIL TEMP indicator)
(1) Create a short circuit between CG (4) and TC (13)
of the DLC3 terminals using SST.
SST 09843−18040
(2) Move the shift lever back and forth between N and
D at 1.5 seconds interval for six seconds.
(3) The A/T OIL TEMP indicator comes on for two se-
conds when the combination meter starts to detect
the fluid temperature.
(4) The A/T OIL TEMP indicator comes on again when
the fluid temperature reaches 46_C (115_F) and
blinks when it exceeds 56_C (130_F).
(5) Allow the engine to idle until the fluid temperature
reaches 46_C (115_F).
FLUID LEVEL CHECK
Remove the overflow plug with the engine idling.
Check that the fluid comes out of the overflow tube.
AT−5