Toyota Tundra 2005 Service - Repair - Maintenance page 2179

Engine Wire Protector
Starter
Connector
STARTING (2UZ−FE) −
INSTALLATION
1. INSTALL STARTER
(a) Install the engine wire protector to the starter with the bolt.
Torque: 9.81 N·m (100 kgf·cm, 84 in.·lbf)
(b) Connect the starter wire with the nut.
Torque: 9.81 N·m (100 kgf·cm, 84 in.·lbf)
(c) Connect the starter connector.
(d) Connect the starter to the cylinder block.
B04549 (e) Connect the engine wire with the bolt.
(f) Install the starter with the 2 bolts.
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
2. INSTALL AIR PUMP ASSEMBLY (See page EC−27)
3. INSTALL INTAKE MANIFOLD ASSEMBLY
(See page EM−60)
4. CONNECT THROTTLE BODY ASSEMBLY TO INTAKE
MANIFOLD (See page SF−45)
5. INSTALL INTAKE AIR CONNECTOR
6. INSTALL THROTTLE BODY COVER
B04548
7. CONNECT CABLE TO NEGATIVE (−) BATTERY TER-
MINAL
STARTER
ST−19
ST08I−05