Toyota Tundra 2005 Service - Repair - Maintenance page 2309

MT−66
MANUAL TRANSMISSION (RA60)
4.
(a)
(b)
D14064
5.
(a)
(b)
D14062
6.
(a)
(b)
(c)
HINT:
Make sure that the shift fork shaft No.4 is in the neutral position.
D14010
7.
(a)
(b)
D14063
8.
(a)
(b)
(c)
HINT:
Make sure that the shift fork shaft No.3 and No.4 are in the neu-
tral position.
D14008
− CONTROL SHAFT ASSEMBLY
INSTALL SHIFT FORK NO.4
Install the shift fork No.4 to the shift fork shaft No.4.
Using a pin punch (5 mm (0.20 in.)) and hammer, tap in
the slotted pin to the shaft fork No.4 and shift fork shaft
No.4.
Drive in depth: 0 to 0.5 mm (0 to 0.0197 in.)
INSTALL SHIFT HEAD NO.2 AND SHIFT FORK NO.1
Install the shift fork No.1 and shift head No.2 to the shift
fork shaft No.4.
Using a pin punch (5 mm (0.20 in.)) and hammer, tap in
the slotted pin to the shift head No.2 and shift fork shaft
No.4.
Drive in depth: 0 to 0.5 mm (0 to 0.0197 in.)
INSTALL SHIFT FORK SHAFT NO.1
Apply MP grease to the interlock pin No.1, and install it to
the interlock bracket.
Install the spring and ball to the interlock bracket.
Install the shift fork shaft No.1 to the interlock bracket.
INSTALL SHIFT HEAD NO.1
Install the shift head No.1 to the shift fork shaft No.1.
Using a pin punch (5 mm (0.20 in.)) and hammer, tap in
the slotted pin to the shift head No.1 and shift fork shaft
No.1.
Drive in depth: 0 to 0.5 mm (0 to 0.0197 in.)
INSTALL SHIFT FORK SHAFT NO.2
Apply MP grease to the interlock pin No.2 and No.3, and
install them to the interlock bracket.
Install the spring and ball to the the interlock bracket.
Install the shift fork shaft No.2 to the interlock bracket.