Parking Brake Pedal - Toyota Tundra 2005 Service - Repair - Maintenance

BR−14
F07755
Adjusting
Nut
Lock Nut
F08199
BRAKE −

PARKING BRAKE PEDAL

PARKING BRAKE PEDAL
ON−VEHICLE INSPECTION
1. CHECK PARKING BRAKE PEDAL TRAVEL
Depress the parking brake pedal all the way and count the num-
ber of clicks.
Parking brake pedal travel at 294 N (30 kgf, 66 lbf):
8 to 10 clicks
If incorrect, adjust the parking brake.
2. IF NECESSARY, ADJUST PARKING BRAKE PEDAL
TRAVEL
HINT:
Before adjusting the parking brake, make sure that the rear
brake shoe clearance has been adjusted. For shoe clearance
adjustment, see step 3 on page BR−52.
(a) Remove the scuff plate LH.
(b) Remove the cowl side trim LH.
(c) Remove the lower finish panel.
(d) Remove the No. 2 heater to register duct.
(e) Loosen the lock nut and turn the adjusting nut until the
pedal travel is correct.
(f) Tighten the lock nut.
Torque: 5.4 N·m (55 kgf·cm, 48 in.·lbf)
(g) Install the removed parts.
BR109−05