IG−10
IGNITION (1GR−FE)
−
CRANKSHAFT POSITION SENSOR
INSTALLATION
1.
INSTALL CRANKSHAFT POSITION SENSOR
(a)
Apply a light coat of engine oil to an O−ring of the crank-
shaft position sensor.
(b)
Install the crankshaft position sensor with the bolt.
Torque: 10 N m (102 kgf cm, 7 ft lbf)
(c)
Connect the crankshaft position sensor connector.
2.
INSTALL COOLER COMPRESSOR
A23147
(a)
Install the cooler compressor assy with the 4 bolts.
Torque: 25 N m (255 kgf cm, 18 ft lbf)
(b)
Connect the cooler compressor assy connector.
(c)
Install the suction hose sub−assy with the bolt.
Torque: 8.0 N m (82 kgf cm, 71 in. lbf)
3.
INSTALL GENERATOR (See page CH−15)
4.
INSTALL ENGINE UNDER COVER
A23146
IG0MO−01