PR−4
Matchmarks
Matchmarks
PROPELLER SHAFT
−
DISASSEMBLY
NOTICE:
Be careful not to grip the propeller shaft tube too tightly in
a vise as this will cause deformation.
1.
SEPARATE PROPELLER SHAFT AND INTERMEDI-
ATE SHAFT
(a)
Place matchmarks on the yoke and propeller shaft.
(b)
Disassemble the center yoke
Q10882
(See SPIDER BEARING REPLACEMENT on page
PR−17).
2.
REMOVE CENTER SUPPORT BEARING FROM IN-
TERMEDIATE SHAFT
(a)
Using a hammer and chisel, loosen the staked part of the
nut.
(b)
Clamp the yoke in a vise and remove the spacer and nut.
(c)
Place matchmarks on the yoke and shaft.
(d)
Using a brass bar and hammer, remove the center yoke,
dust cover, spacer and center support bearing from the in-
termediate shaft.
Q10880
PROPELLER SHAFT ASSEMBLY (2WD)
PR05K−02