Toyota Tundra 2005 Service - Repair - Maintenance page 2398

PROPELLER SHAFT −
INSPECTION
NOTICE:
Be careful not to grip the propeller shaft tube too tightly in
a vise as this will cause deformation.
1. INSPECT PROPELLER SHAFT AND INTERMEDIATE
SHAFT FOR DAMAGE OR RUNOUT
Using a dial indicator, check the runout of each shaft.
Maximum runout: 0.8 mm (0.031 in.)
Z04240 If shaft runout is greater than the maximum, replace it.
2. INSPECT SPIDER BEARING
(a) Inspect the spider bearing for wear or damage.
(b) Using a dial indicator, check the spider bearing axial play
by turning the yoke of the flange while holding the shaft
tightly.
Maximum bearing axial play: 0.05 mm (0.0020 in.)
If the spider bearing axial play exceeds the maximum, replace
the spider bearing (See page PR−17).
Z04241
3. INSPECT CENTER SUPPORT BEARING FOR WEAR
OR DAMAGE
Check that the bearing turns freely.
If the bearing is damaged, worn, or does not turn freely, replace
it.
R04478
PROPELLER SHAFT ASSEMBLY (2WD)
PR−5
PR01J−03