Toyota Tundra 2005 Service - Repair - Maintenance page 2368

High and Low
Shift Fork
Snap Ring
Shift Fork Shaft
TRANSFER
(d)
F07968
(e)
HINT:
Check that the rear output shaft assembly and driven sprocket
assembly turn slightly.
F08461
12.
(a)
F07980
(b)
Front Drive
Shift Fork
(c)
NOTICE:
Make sure that the shift fork shaft is installed in the correct
direction.
Snap Ring
F08799
− TRANSFER ASSEMBLY
Using a snap ring expander, install the snap ring.
Using a screwdriver and hammer, drive in the snap ring
to the shift fork shaft of the actuator assembly.
INSTALL SHIFT FORK SHAFT
Using a magnetic finger, install the 2 straight pins to the
front drive and high and low shift forks.
To push into the shift fork shaft, shift the front drive and
high and low shift forks to the positions as shown in the
illustration.
Push into the shift fork shaft.
TR−19