Toyota Tundra 2005 Service - Repair - Maintenance page 2267

MT−24
15°
Claw
B
A
B
A
A
A
MANUAL TRANSMISSION (RA60)
NOTICE:
Make sure that the screw hole of the reverse idler shaft is
positioned as shown in the illustration.
D13934
6.
Fit the notch of the shift & select cam to the reverse idler gear
shaft, and the claw to the gap on the control shaft assembly to
install the shift & select lever shaft.
Notch
D13935
7.
FIPG
(a)
D14047
(b)
B
A
B
B
A
D14031
(c)
HINT:
Make sure that the protruding parts on the receiver pipe are
fitted into the holes on the middle case.
D13936
− MANUAL TRANSMISSION ASSEMBLY
INSTALL SHIFT & SELECT LEVER SHAFT
INSTALL MIDDLE CASE
Apply FIPG to the middle case as shown in the illustration.
FIPG:
Part No. 08826−00090, THREE BOND 1281 or equiva-
lent
Install the middle case to the front case with the 11 bolts.
Torque: 40 N·m (408 kgf·cm, 30 ft·lbf)
Bolt length:
Bolt A: 40 mm (1.57 in.)
Bolt B: 80 mm (3.15 in.)
Install the oil receiver pipe to the middle case.