Toyota Tundra 2005 Service - Repair - Maintenance page 2353

TR−4
TRANSFER − TRANSFER UNIT
REMOVAL
HINT:
Be sure to switch the transfer to 2WD before performing proce-
dures.
1. DISCONNECT BREATHER HOSE
Disconnect the breather hose from the transfer.
2. RAISE VEHICLE AND DRAIN TRANSFER OIL
3. REMOVE LH AND RH FRONT EXHAUST PIPES
(See page EM−126)
4. REMOVE FRONT AND REAR PROPELLER SHAFTS
(See page PR−10)
5. REMOVE CROSSMEMBER
(a) Remove the 2 bolts and heat insulator.
(b) Support the rear side of the transmission with a transmis-
sion jack.
(c) Remove the 4 bolts.
(d) Remove the 4 bolts, nuts and crossmember.
6. REMOVE ENGINE REAR MOUNTING
Remove the 4 bolts and engine rear mounting from the transfer
adaptor.
7. DISCONNECT TRANSFER DETECTION SWITCHES
AND MOTOR ACTUATOR CONNECTORS
(See page TR−3)
F07999
8. REMOVE TRANSFER
(a) Support the transfer with another transmission jack.
(b) Remove the 8 transfer mounting bolts and clamps.
(c) Pull the transfer out from the transfer adaptor down and
toward the rear.
F08000
TR09H−02