Toyota Tundra 2005 Service - Repair - Maintenance page 2401

PR−8
Except
Double−Cab
model:
Matchmarks
90_
Center Bearing Center Line
6.0 ± 1.0 mm (0.236 ± 0.039 in.)
Center Bearing Housing Center Line
PROPELLER SHAFT
Double−Cab
model:
Matchmarks
F19350
Bracket Center
Line
Shaft Axial
Direction
F07983
Q07263
− PROPELLER SHAFT ASSEMBLY (2WD)
INSTALLATION
1. INSTALL PROPELLER SHAFT
(a) Remove SST from the transmission.
SST 09325−40010
(b) Insert the yoke into the transmission.
(c) Temporarily install the center support bearing with the 2
mounting bolts.
HINT:
Make sure the bearing is installed with the drain hole facing
downwards.
(d) Except Double−Cab model:
Align the matchmarks on the flanges and connect the
flanges with the 4 bolts, washers and nuts.
(e) Torque the 4 bolts.
Torque: 88 N·m (897 kgf·cm, 65 ft·lbf)
(f) Double−Cab model:
Align the matchmarks on the flanges and connect the
flanges with the 4 washers and nuts.
(g) Torque the 4 nuts.
Torque: 88 N·m (897 kgf·cm, 65 ft·lbf)
2. ADJUST CENTER SUPPORT BEARING
HINT:
S
With the vehicle unloaded, adjust the center support
bearing to keep the angles, as shown.
S
Under the same conditions, check the center line in the
axial direction. Adjust the bearing if necessary.
S
The center bearing center line and center bearing hous-
ing center line must be adjusted to within 6.0 ± 1.0 mm
(0.236 ± 0.039 in.) of each other in the vehicle's longitudi-
nal direction with the vehicle unloaded.
Torque the 2 bolts.
Torque: 40 N·m (410 kgf·cm, 30 ft·lbf)
PR05M−03