Toyota Tundra 2005 Service - Repair - Maintenance page 2065

Hide thumbs Also See for Tundra 2005:

Table of Contents

LUBRICATION (1GR−FE)

When using a container:

When using a drain hose:

OIL AND FILTER

Prolonged and repeated contact with engine oil will

result in the removal of natural oils from the skin,

leading to dryness, irritation and dermatitis. In addi-

tion, used engine oil contains potentially harmful

contaminants which may cause skin cancer.

Precautions should be taken when replacing engine

oil to minimize the risk of contact with used engine oil.

Protective clothing and gloves that cannot be pene-

trated by oil should be worn. The skin should be

washed with soap and water, or use water−less hand

cleaner, to remove any used engine oil thoroughly. Do

not use gasoline, thinners, or solvents.

In order to preserve the environment, used oil and

used oil filters must be disposed of at designated dis-

posal sites.

DRAIN ENGINE OIL

Remove the engine under cover seal No. 3.

Remove the oil pan drain plug and drain the engine oil.

Clean the oil pan drain plug and install it and a new gas-

Torque: 40 N m (408 kgf cm, 30 ft lbf)

REMOVE OIL FILTER

Remove the drain pipe cap.

While removing the oil filter with SST, catch the oil from the

oil filter with a container.

Install the drain pipe cap.

Clean the oil catch plate.

Remove the drain pipe cap.

Connect a drain hose to the oil filter bracket.

Drain hose inside diameter: 8 mm (0.31 in.)

Drain hose length: 900 mm (35.43 in.)

Pass the drain hose down through the engine under cov-

er, and put the drain oil container beneath the drain hose

in order to catch the oil from the oil filter.