Toyota Tundra 2005 Service - Repair - Maintenance page 2096

A
B
New O−Ring
Engage
A
A
A
C
D
A
LUBRICATION (2UZ−FE)
INSTALLATION
1.
A
(a)
B
Seal Width
(b)
2 − 3 mm
NOTICE:
Avoid applying an excessive amount to the surface. Be par-
ticularly careful near oil passage.
B13060
(c)
(d)
P21388
(e)
E
B
B00950
− OIL PUMP
INSTALL OIL PUMP
Remove any old packing (FIPG) material and be careful
not to drop any oil on the contact surfaces of the oil pump
and cylinder block.
S
Using a razor blade and gasket scraper, remove all
the old packing (FIPG) material from the gasket sur-
faces and sealing groove.
S
Thoroughly clean all components to remove all the
loose material.
S
Using a non−residue solvent, clean both sealing
surfaces.
Apply seal packing to the oil pump as shown in the illustra-
tion.
Seal packing: Part No. 08826−00080 or equivalent
S
Install a nozzle that has been cut to a 2 − 3 mm (0.08
− 0.12 in.) opening.
S
Parts must be assembled within 3 minutes of ap-
plication. Otherwise the material must be removed
and reapplied.
S
Immediately remove nozzle from the tube and rein-
stall cap.
Install a new O−ring to the cylinder block.
Engage the spline teeth of the oil pump drive gear with the
large teeth of the crankshaft, and slide the oil pump on the
crankshaft.
Install the oil pump with the 8 bolts. Uniformly tighten the
bolts in several passes.
Torque:
30.5 N·m (310 kgf·cm, 22 ft·lbf) for 14 mm head
15.5 N·m (160 kgf·cm, 11 ft·lbf) for others
LU−15
LU0GY−07