Toyota Tundra 2005 Service - Repair - Maintenance page 2171

Ohmmeter
No Continuity
Lock
Terminal 50
Continuity
Terminal C
STARTING (2UZ−FE)
11.
Take the pull scale reading the instant the brush spring sepa-
rates from the brush.
ST0019
If the installed load is less than minimum, replace the brush
springs.
12.
Using an ohmmeter, check that there is no continuity between
the positive (+) and negative (−) brush holders.
If there is continuity, repair or replace the brush holder.
13.
Check the gear teeth on the pinion gear, idle gear and the clutch
assembly for wear or damage.
If damaged, replace the gear or clutch assembly.
If damaged, also check the drive plate ring gear for wear or
P21088
damage.
14.
Rotate the pinion gear clockwise, and check that it turns freely.
Free
Try to rotate the pinion gear counterclockwise and check that
it locks.
If necessary, replace the clutch assembly.
15.
Turn the bearing by hand while applying inward force.
If resistance is felt or the bearing sticks, replace the bearing.
P10821
16.
Ohmmeter
Using an ohmmeter, check that there is continuity between ter-
minals 50 and C.
If there is no continuity, check and replace the magnetic switch.
B04553
− STARTER
INSPECT BRUSH SPRING LOAD
Standard spring installed load:
1.4 kW type 17.6 to 23.5 N (1.8 to 2.4 kgf, 4.0 to 5.3 lbf)
2.0 kW type 21.5 to 27.5 N (2.2 to 2.8 kgf, 4.8 to 6.2 lbf)
Minimum spring installed load:
1.4 kW type
2.0 kW type
INSPECT BRUSH HOLDER INSULATION
INSPECT GEAR TEETH
INSPECT CLUTCH PINION GEAR
INSPECT FRONT AND REAR BEARING
DO PULL−IN COIL OPEN CIRCUIT TEST
11.8 N (1.2 kgf, 2.7 lbf)
12.7 N (1.3 kgf, 2.9 lbf)
ST−11