Toyota Tundra 2005 Service - Repair - Maintenance page 2299

MT−56
1st Gear Side:
Groove
SST
MANUAL TRANSMISSION (RA60)
REASSEMBLY
1.
(a)
(b)
(c)
(d)
(e)
NOTICE:
Be careful not to scatter the balls.
2nd Gear Side:
D13992
2.
(a)
(b)
D13993
(c)
HINT:
Make sure that the protruding part on the synchronizer ring is
fitted into the groove of the clutch hub.
(d)
Protruding Part
D13994
− COUNTER GEAR
REASSEMBLE CLUTCH HUB NO.1
Apply gear oil to the clutch hub sleeve and clutch hub.
Install the clutch hub sleeve to the clutch hub.
Install the 3 shifting keys to the clutch hub.
Install the 3 shifting key springs to the clutch hub.
Place the balls on the holes on the shifting keys, and
install the hub sleeve while pushing down the balls.
INSTALL 2ND GEAR
Apply gear oil to the needle roller bearing and 2nd gear
taper cone.
Install the needle roller bearing, 2nd gear and synchroniz-
er ring set No.1 to the counter shaft.
Using SST and a press, install the clutch hub No.1.
SST 09308−14010
Make sure that the gear and synchronizer ring move
smoothly.
MT0I5−01