30°30°
Jiggle Valve
COOLING (2UZ−FE)
−
THERMOSTAT
INSTALLATION
1.
PLACE THERMOSTAT IN WATER INLET HOUSING
(a)
Install a new gasket to the thermostat.
(b)
Insert the thermostat into the water inlet housing with the
jiggle valve facing straight upward.
HINT:
The jiggle valve may be set within 30° of either side of the pre-
scribed position.
B07218
2.
INSTALL WATER INLET
Install the water inlet with the 3 nuts.
Torque: 19 N·m (195 kgf·cm, 14 ft·lbf)
3.
FILL WITH ENGINE COOLANT
4.
START ENGINE AND CHECK FOR COOLANT LEAKS
5.
RECHECK ENGINE COOLANT LEVEL
CO−13
CO0IX−03