CH−8
SST (B)
CHARGING (2UZ−FE)
DISASSEMBLY
1.
(a)
(b)
(c)
B16510
2.
(a)
(b)
B16392
3.
(a)
B16393
(b)
(c)
B12164
4.
(a)
Turn
SST (A)
(b)
P13597
−
GENERATOR (Standard Spec.)
REMOVE REAR END COVER
Remove the nut and terminal insulator.
Remove the bolt 3 nuts, plate terminal and end cover.
Remove the brush holder cover from the brush holder.
REMOVE BRUSH HOLDER
Remove the 2 screws and brush holder.
Remove the seal plate from the rectifier end frame.
REMOVE VOLTAGE REGULATOR AND RECTIFIER
HOLDER
Remove the 3 screws and voltage regulator.
Remove the 4 screws and rectifier holder.
Remove the 4 rubber insulators.
REMOVE PULLEY
Hold SST (A) with a torque wrench, and tighten SST (B)
clockwise to the specified torque.
SST
09820−63011
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
Check that SST (A) is secured to the rotor shaft.
CH0LN−01