Toyota Tundra 2005 Service - Repair - Maintenance page 2251

MT−8
MANUAL TRANSMISSION (RA60)
6.
Install the clutch release cylinder with the 2 bolts.
D13772
7.
(a)
D13771
(b)
(c)
D13770
8.
Install the clutch housing cover with the 3 bolts.
(a)
(b)
9.
D13769
10.
11.
12.
Install the 2 stabilizer bar brackets with the 2 bolts and nuts.
− MANUAL TRANSMISSION UNIT
INSTALL CLUTCH RELEASE CYLINDER
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
INSTALL CLUTCH ACCUMULATOR
Install the clutch accumulator with the 3 bolts.
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
Using SST, connect the clutch lines to the clutch release
cylinder and clutch accumulator.
SST 09023−00101
Torque: 15 N·m (155 kgf·cm, 11 ft·lbf)
Install the clamp with the bolt.
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
INSTALL CLUTCH HOUSING COVER
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
Install the clutch accumulator with the 3 bolts.
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
Install the clutch housing cover with the 3 bolts.
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
CONNECT VEHICLE SPEED SENSOR, BACK−UP
LIGHT SWITCH CONNECTOR
INSTALL PROPELLER SHAFT (See page PR−8)
INSTALL LH AND RH FRONT EXHAUST PIPE
(See page EM−127)
INSTALL STABILIZER BAR BRACKET
Torque: 37 N·m (377 kgf·cm, 27 ft·lbf)