Toyota Tundra 2005 Service - Repair - Maintenance page 2337

AUTOMATIC TRANSMISSION (A750E, A750F)
Speed Sensor NT
Speed Sensor SP2
− AUTOMATIC TRANSMISSION UNIT (1GR−FE)
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
2. JACK UP VEHICLE
3. REMOVE NO. 1 ENGINE UNDER COVER
4. DRAIN AUTOMATIC TRANSMISSION FLUID
(a) Remove the drain plug and gasket, and drain the ATF.
(b) Install a new gasket and the drain plug.
Torque: 20 N·m (204 kgf·cm, 15 ft·lbf)
5. REMOVE RH AND LH FRONT EXHAUST PIPE
(See page EM−138)
6. REMOVE PROPELLER SHAFT (See page PR−3)
D13867
7. DISCONNECT SPEED SENSOR NT AND SP2 CON-
NECTORS
D14125
8. DISCONNECT TRANSMISSION WIRE CONNECTOR
D13875
AT−27
AT13Y−01