RS-84
SUPPLEMENTAL RESTRAINT SYSTEM
-
CURTAIN SHIELD AIRBAG ASSEMBLY
REMOVAL
HINT:
z
Use the same procedures for the RH side and LH side.
z
The procedures listed below are for the LH side.
NOTICE:
z
If the wiring connector of the SRS is disconnected
and the ignition switch is in the ACC or ON position,
DTCs will be recorded.
z
Never use airbag parts from another vehicle. When
replacing parts, replace them with new ones.
1.
PRECAUTION (SEE PAGE
2.
DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
Wait for 90 seconds after disconnecting the cable to prevent the
airbag working.
3.
REMOVE ROOF HEADLINING (SEE PAGE
AND
BO-133
)
4.
REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY
(a)
Disconnect the curtain shield airbag connector.
NOTICE:
When handling the airbag connector, take care not to dam-
age the airbag wire harness.
(b)
Remove the 13 bolts and the curtain shield airbag assem-
bly.
Author :
RS-1
AND
RS-3
)
BO-126
Date :
RS10V-02
H23220
4499