Toyota Tundra 2005 Service - Repair - Maintenance page 2066

LU−4
SST
SST
LUBRICATION (1GR−FE)
(h) Using SST, remove the oil filter.
SST
(i) Remove the drain hose and install the drain pipe cap.
(j) Clean the oil catch plate.
A23130
3. INSTALL OIL FILTER
(a) Clean the oil filter contact surface on the oil filter bracket.
(b) Lubricate the rubber gasket of a new oil filter with clean
engine oil.
(c) Tighten the oil filter by hand until the rubber gasket con-
tacts the seat of the filter bracket.
A23131
(d) Using SST, give it an additional 3/4 turn to set the filter.
SST
4. ADD ENGINE OIL
3/4 Turn
(a) Fill with new engine oil.
Capacity:
Drain and refill:
w/ Oil filter change: 4.5 liters (4.8 US qts, 4.0 lmp. qts)
w/o Oil filter change: 4.2 liters (4.4 US qts, 3.7 lmp. qts)
Dry fill: 5.6 liters (5.9 US qts, 4.9 lmp. qts)
A23132
(b) Reinstall the oil filler cap.
5. CHECK FOR ENGINE OIL LEAKS
6. CHECK ENGINE OIL LEVEL
− OIL AND FILTER
09228−07501
09228−07501