MT−22
Protruding Part
Notch
A
MANUAL TRANSMISSION (RA60)
(c)
D14037
(d)
HINT:
Make sure that the protruding part on the oil receiver pipe is
fitted into the hole on the rear case.
D14042
(e)
HINT:
Make sure that the protruding part on the transmission oil sepa-
rator seal is fitted into the notch on the rear case.
D14043
3.
(a)
SST
(b)
D14044
(c)
HINT:
Make sure that the protruding parts on the oil receiver pipe is
fitted into the holes on the extension housing.
D14045
−
MANUAL TRANSMISSION ASSEMBLY
Install the bearing lock plate with the bolt.
Torque: 11 N·m (115 kgf·cm, 8 ft·lbf)
Install the oil receiver pipe to the rear case.
Install the transmission oil separator seal to the rear case.
REASSEMBLE EXTENSION HOUSING
Using SST and a hammer, tap in a new oil seal to the ex-
tension housing until dimension A falls within the speci-
fied range.
SST
09950−60020 (09951−00640), 09950−70010
(09951−07100)
Dimension A: −0.5 to 0.5 mm (−0.0197 to 0.0197 in.)
Apply gear oil to the lip of the oil seal.
Install the oil receiver pipe to the extension housing.