Toyota Tundra 2005 Service - Repair - Maintenance page 2348

AT−38
AUTOMATIC TRANSMISSION (A750E, A750F)
Dimension B
INSTALLATION
1. CHECK TORQUE CONVERTER INSTALLATION
(a) Install the torque converter to the transmission housing.
(b) Using vernier calipers and a straight edge, measure di-
mension A between the transmission fitting part and the
converter fitting part of the drive plate.
A
D14133
(c) Using vernier calipers and a straight edge, measure the
dimension B shown in the illustration and check that B is
greater than A measured in step (b).
Standard distance: A + 1 mm (0.04 in.) or more
2. MEASURE DRIVE PLATE RUNOUT AND INSPECT
RING GEAR (See page AT−39)
3. TRANSMISSION INSTALLATION
(a) Installation is in the reverse order of removal
(See page AT−34).
D14130
(b) Adjust the shift lever position (See page DI−1117).
(c) Fill the transmission (See page AT−4).
(d) Conduct the road test of the vehicle (See page DI−1118).
− AUTOMATIC TRANSMISSION UNIT (2UZ−FE)
AT142−01