29 mm
Socket
Wrench
SST (B)
CHARGING (2UZ−FE)
REASSEMBLY
1.
2.
N00556
3.
(a)
CH1030
(b)
B04530
(c)
B16527
4.
(a)
(b)
Turn
SST (A)
(c)
P13597
−
GENERATOR (Standard Spec.)
PLACE RECTIFIER END FRAME ON PULLEY
INSTALL ROTOR TO DRIVE END FRAME
INSTALL RECTIFIER END FRAME
Place the generator washer on the rotor.
Using a 29 mm socket wrench and press, slowly press in
the rectifier end frame.
Install the 4 nuts.
Torque: 4.5 N·m (46 kgf·cm, 39 in.·lbf)
INSTALL PULLEY
Install the pulley to the rotor shaft by tightening the pulley
nut by hand.
Hold SST (A) with a torque wrench, and tighten SST (B)
clockwise to the specified torque.
SST
09820−63011
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
Check that SST (A) is secured to the pulley shaft.
CH−13
CH0LP−01