Checking The Gear Shift Operation - SELVA MARINE Blue Whale 250 EFI Service Manual

CHK
ADJ
6. Operate the remote control lever several
times, and then check that the mark b
on the lever 4 has passed the mark c
on the stopper 5 when the remote con-
trol lever is in the fully open position of
the throttle.
4
7. Check that the lever 4 contacts the fully
closed stopper 5 when the remote con-
trol lever is in the fully closed position.
8. Check the throttle cable for smooth oper-
ation and, if necessary, repeat steps 2–7.

Checking the gear shift operation

1. Check that the gear shift operates
smoothly when shifting it from the neutral
position to forward or reverse. Adjust the
shift cable length if necessary.
2. Check the neutral switch for continuity.
Adjust the shift cable length or check the
neutral switch if necessary.
NOTE:
To check the neutral switch, see Chapter 8,
"Checking the neutral switch."
Gear shift
Blue/green
position
Forward or
reverse
Neutral
3. Set the gear shift to the neutral position.
3-11
Periodic check and adjustment
c
b
5
S6P23360
Lead color
Black (B)
(L/G)
4. Loosen the locknut 1, remove the clip
2, and then disconnect the shift cable
joint 3.
5. Align the alignment mark a on the bush-
ing and alignment mark b on the
bracket.
6. Adjust the position of the shift cable joint
until its hole is aligned with the set pin.
WARNING
The shift cable joint must be screwed in a
minimum of 8.0 mm (0.31 in) c.
7. Connect the cable joint, install the clip,
and then tighten the locknut.
S69J3370
6P23H11