Start-In-Gear Protection - SELVA MARINE MARLIN 100 EFI Owner's Manual

General information
x -
1 2 3
1. Propeller diameter in inches
2. Propeller pitch in inches
3. Type of propeller (propeller mark)
x -
1 2 3
1. Propeller diameter in inches
2. Propeller pitch in inches
3. Type of propeller (propeller mark)
NOTE:
Select a propeller which will allow the engine
to reach the middle or upper half of the oper-
ating range at full throttle with the maximum
boat load. If operating conditions such as light
boat loads then allow the engine r/min to rise
above the maximum recommended range, re-
duce the throttle setting to maintain the en-
gine in the proper operating range.
For instructions on propeller removal and in-
stallation, see page 45.
5
EMU25760

Start-in-gear protection

Selva outboard motors affixed with the pic-
tured label or Selva-approved remote con-
trol units are equipped with start-in-gear
protection device(s). This feature permits the
engine to be started only when it is in neutral.
Always select neutral before starting the en-
gine.
ZMU04606
1. Start-in-gear protection label
ZMU04607
1
ZMU01713