Checking The Gear Shift Operation - SELVA MARINE Grey Whale 200 EFI Service Manual

NOTE:
Pull the throttle cable towards the engine to
remove any free play in the cable before
adjusting the position of the throttle cable
joint.
5. Connect the throttle cable joint 3, install
the clip 2, and then tighten the locknut
1.
6. Operate the remote control lever several
times, and then check that the mark b
on the accelerator lever 4 has passed
the mark c on the fully closed stopper 5
when the remote control lever is in the
fully open position of the throttle.
4
7. Check that the accelerator lever 4 con-
tacts the fully closed stopper 5 when the
remote control lever is in the fully closed
position.
8. Check the throttle cable for smooth oper-
ation and, if necessary, repeat steps 2–7.
6AL3J11
3
2
1
S6P23350
c
b
5
S6P23360
Power unit / Control system

Checking the gear shift operation

1. Check that the gear shift operates
smoothly when shifting it from the neutral
position to forward or reverse. Adjust the
shift cable length if necessary.
2. Check the neutral switch for continuity.
Adjust the shift cable length or check the
neutral switch if necessary.
NOTE:
To check the neutral switch, see Chapter 8,
"Checking the neutral switch."
Gear shift
Blue/green
position
(L/G)
Forward or
reverse
Neutral
3. Set the gear shift to the neutral position.
4. Loosen the locknut 1, remove the clip
2, and then disconnect the shift cable
joint 3.
Lead color
Black (B)
3-12
1
2
3
4
5
6
7
8
9