Checking The Cooling Water Passage; Control System; Adjusting The Throttle Cable (Tiller Handle Model) - SELVA MARINE Wahoo 15 Service Manual

CHK
ADJ

Checking the cooling water passage

1. Check the cooling water inlet covers 1
and cooling water inlets, clean if clogged.
1
2. Place the lower unit in water, and then
start the engine.
3. Check for water flow at the cooling water
pilot hole. If there is no water flow, check
the cooling water passages inside the
outboard motor.
3-7
Periodic check and adjustment
1
S6D53130
S6AG3170
S6AG1230

Control system

3
Adjusting the throttle cable (tiller
handle model)
1. Disconnect the throttle link rod 1 from
the free accel lever.
2. Loosen the locknuts 2 and 3, and then
turn the adjusting nuts 4 and 5 to
loosen the throttle cables 6 and 7.
1
3. Turn the throttle grip to the fully open
position and hold it in place.
4. Turn the adjusting nut 5 so that the fully
open stopper a on the throttle cam con-
tacts the throttle cam bracket as shown,
and then tighten the locknut 3.
NOTE:
Be careful not to pull the outer cables too
much towards the power unit as they could
be pulled out of the grommet. If the outer
cables are pulled out of the grommet, see
"Assembling the tiller handle" (7-3).
5. Turn the adjusting nut 4 to remove the
slack in the throttle cable 6, and then
tighten the locknut 2.
a
6 2 4
7 3 5
2
6
3
3
3
S6AG3300J
4
5
S6AG3330J
6AG3J11