Removing The Clamp Bracket; Installing The Clamp Bracket; Installing The Ptt Unit - SELVA MARINE Blue Whale 250 EFI Service Manual

BRKT

Removing the clamp bracket

1. Remove the self-locking nut 1 of the
through tube and ground lead 2, then
clamp brackets 3 and 4.
2. Remove the trim sensor 5.

Installing the clamp bracket

1. Install the trim sensor 1 onto the star-
board clamp bracket.
NOTE:
Adjust the trim sensor after installing the PTT
unit. To adjust the trim sensor, see "Adjusting
the trim sensor."
2. Assemble the clamp brackets and the
swivel bracket by connecting the ground
lead 2, installing the through tube 3,
then tightening the self-locking nut 4
temporary.
7-19
Bracket unit
Grease nipple 5:
3 N·m (0.3 kgf·m, 2.2 ft·lb)

Installing the PTT unit

1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1.
WARNING
• When installing the PTT unit with the
power unit installed, be sure to suspend
the outboard motor. If the outboard
motor is not suspended it can fall sud-
denly and result in severe injury.
• After tilting the outboard motor up, be
sure to support it with the tilt stop lever.
2. Install the PTT unit mounting bolts 2
onto both clamp brackets together with
the PTT unit 3, and then tighten them.
6P23H11